From: Arun Tomar <tomar.arun@...>
Date: 2012-05-28T22:09:04+09:00
Subject: Re: rubygem: ispunity (unite all your internet connections)

Dear Prashant,

ispunity commands have to run in a sequence

1. ispunity setup
this will setup all the rules, policies and routing table entries, if 
you've configured your json configuration file properly.

2. then you can run
"ispunity monitor " as a cron for dead gateway detection and automatic 
failover.

All these instructions will be updated in the new version to be released 
shortly. Feel free to mail us for further queries. We are here to help 
people to use ispunity and will provide whatever support necessary. Enjoy :)

Arun.

On 05/28/2012 06:30 PM, Prashant T. wrote:
> Respected sir,
> first of all very very thanks for taking this initiative to solve
> problem of many like us who can't afford 3g and broadband but we can
> have more than one mobile at our room and we were in need to combine all
> of them to improve internet speed, and with your software we again
> reveice hope,
> many many thanks.
>
> but still there r some problems in settings,
>
> as you have given
> =======================================================================
> Normal scenario: (1 gateway)
>
> Check the last line “default via<  ip your gateway>  dev<  device name>
>
> [root@router ~]# ip route show
> 61.17.193.0/24 dev eth0 proto kernel scope link src 61.17.193.163
> 192.168.3.0/24 dev eth1 proto kernel scope link src 192.168.3.1
> 192.168.0.0/24 dev eth2 proto kernel scope link src 192.168.0.1
> 192.168.122.0/24 dev virbr0 proto kernel scope link src 192.168.122.1
> 169.254.0.0/16 dev eth0 scope link metric 1002
> 169.254.0.0/16 dev eth1 scope link metric 1003
> 169.254.0.0/16 dev eth2 scope link metric 1004
> default via 192.168.0.2 dev eth2
> =======================================================================
>
> i got it with two ppp connections but as we are not linux geek so we
> were unable to get below things working
> =======================================================================
> 169.254.0.0/16 dev eth0 scope link metric 1002
> 169.254.0.0/16 dev eth1 scope link metric 1003
> 169.254.0.0/16 dev eth2 scope link metric 1004
> =======================================================================
>
> will you please give instructions to do this if it possible with ppp
> connections?
>
> actually really this needs to do remaining things?
>
> because all steps are working but i m not getting any result with
> "iptraf"
>   software.
>
>
> please help us!
>
>
> once again thanks a lot!
>


-- 
Regards,
Arun.