From: Jim Weirich Date: 2004-09-09T15:12:12+09:00 Subject: Re: Rakeforms T. Onoma wrote: > I sent off an email too "Jim Weirich" but I'm not sure > if he (you) got it. So I thought I just post here. I did get it ... thoughts below ... > I was using a certain rakefile a lot so I modified it to read a yaml file for > its needed parameters. It seem pretty useful in general so I though other > might like it,or like to improve on it (it's for package management and > development stuff), so I put in with rake itself and modified rak to check > for a Rake.yaml file if no Rakefile was found. The Rake.yaml file specifies > which Rakeform to use and it goes form there. Could you provide a specific example of how you use this? In many ways, a Rakefile is a configuration file for building software, and I'm a little hesitant to add a config file for a config file unless there are compelling reasons. -- -- Jim Weirich jim@weirichhouse.org http://onestepback.org ----------------------------------------------------------------- "Beware of bugs in the above code; I have only proved it correct, not tried it." -- Donald Knuth (in a memo to Peter van Emde Boas)