[ruby-core:46584] Re: [ruby-trunk - Feature #6762][Open] Control interrupt timing

> * Thread.control_interrupt
> * Thread.check_interrupt

Eek. Please don't use 'interrupt' word. It makes a lot of confusing to
Unix programmer.


>
> Rdoc documents are:
>
>   call-seq:
>     Thread.control_interrupt(hash) { ... } -> result of the block
>
>   Thread.control_interrupt controls interrupt timing.
>
>   _interrupt_ means asynchronous event and corresponding procedure
>   by Thread#raise, Thread#kill, signal trap (not supported yet)
>   and main thread termination (if main thread terminates, then all
>   other thread will be killed).

No. control_interrupt should NOT inhibit running trap procedure. Because of,
Thread.control_interrupt() is per-thread, but trap is not per-thread.

btw, Probably it should be per-fiber instead of per-thread.


>   _hash_ has pairs of ExceptionClass and TimingSymbol.  TimingSymbol
>   is one of them:
>   - :immediate   Invoke interrupt immediately.
>   - :on_blocking Invoke interrupt while _BlockingOperation_.

I don't think 'on_blocking' is good name. Example, pthread cancel have
a 'cancellation point' concept and many blocking functions is defined
as cancellation point. but a few non blocking functions also defined
as cancellation point. So, this on_blocking should have a name as
concept likes interruptible point. (but again, i don't like interrupt
word)


>   - :never       Never invoke interrupt.